Slippa is a ‘super-spreader’ containing an organosilicone/linear alcohol surfactant blend. It designed for use with fungicide materials for the control of eyespot, and where swifter coverage of difficult-to-wet areas is required, ensuring the chemical is quickly moved to the point of action (e.g. through a dense crop canopy). KEY BENEFITS OF USING SLIPPA Slippa is able to significantly reduce the surface tension of the spray solution far below the level achieved by conventional surfactants. This results in: superior contact to the target, ensuring that the chemical is fully spread over the intended target (especially over waxy surfaces); swifter penetration of difficult-to-wet areas, ensuring the chemical is quickly moved to the point of action (e.g. through a dense crop canopy). WHERE TO USE SLIPPA In cereals (for control of stem based diseases, especially eyespot), Oilseed Rape (for use with sulphur), in horticultural crops, and in all situations where an improvement in coverage is required.

USE In winter and spring cereals: for use with all approved fungicides and mixtures containing such products applied at full rate and approved timings; for use with all approved herbicides, plant growth regulators and insecticides applied at full rate upto and including GS 52 (1/4 inflorescence), and at half the approved rate thereafter. In Other Crops: for use with all approved pesticides applied at full rate upto and including the following crop growth stages, and with all approved pesticides applied at half the approved pesticide rate thereafter: Crop/Product To be applied at or before the following crop growth stages: Apples/pears up to and including fruit 5 - 10mm (EPPO code 71) Beans up to and including first pod set (EPPO code 204) Peas up to and including flat pod (EPPO code 205) (non-edible pods only) Edible podded peas up to and including pod set (EPPO code 204) Oilseed Rape up to and including 10% potential pods (code 5.1, Sylvester-Bradley, 1985) Linseed up to and including 10% capsules formed (code 51, Freer 1991) Sugar Beet up to and including 6 fully expanded leaves (EPPO code 23) Maize up to and including tip of tassle visible (EPPO code 53) Potatoes up to and including tuber initiation Cauliflower up to and including cauliflower heads begin to form; width of growing tip up to 1 cm2 for use with approved pesticides at up to full rate application in non-crop, amenity and forestry situations. For specific recommendations consult Interagro (UK) Ltd or its agents.

RATES OF USE Use Slippa at a rate to give a 0.05% to 0.2% dilution of the final water volume in the spray tank, depending on the pesticide in use, and the target disease, weed or crop. Spray volume Rate of use/ha Area treated/1L 200L/ha 200ml 5.00ha 100L/ha 100ml 10.0ha

MIXING Half fill the spray tank with clean water and commence agitation. Add the required quantity of Slippa then add the recommended quantity of pesticide. Continue agitation while topping up the tank and during spraying. If foaming occurs, add the required quantity of Abate to remove foam.

PRECAUTIONS WEAR SUITABLE PROTECTIVE CLOTHING (COVERALLS), SUITABLE PROTECTIVE GLOVES AND FACE PROTECTION (FACESHIELD) when handling the concentrate. WASH CONCENTRATE from skin or eyes immediately. WASH ALL PROTECTIVE CLOTHING thoroughly after use, especially the insides of gloves. WASH HANDS AND EXPOSED SKIN before meals and after work. WHEN USING DO NOT EAT, DRINK OR SMOKE. DO NOT BREATHE SPRAY. KEEP AWAY FROM FOOD, DRINK AND ANIMAL FEEDING STUFFS. KEEP OUT OF REACH OF CHILDREN. DO NOT CONTAMINATE SURFACE WATERS OR DITCHES with chemical or used container. KEEP IN ORIGINAL CONTAINER, tightly closed, in a safe place. WASH OUT CONTAINER THOROUGHLY, and dispose of safely. DO NOT RE-USE CONTAINER for any other purpose. IN CASE OF CONTACT WITH EYES, RINSE IMMEDIATELY with plenty of water and seek medical advice. USE ONLY IN WELL VENTILATED AREAS. Follow all operator exposure instructions for the pesticide. To avoid risks to man and the environment, comply with the instructions for use. STATUTORY CONDITIONS RELATING TO USE FOR USE ONLY AS AN AGRICULTURAL, HORTICULTURAL, FORESTRY AND AMENITY SPREADING AND WETTING AGENT Maximum individual dose: 400 ml of product per hectare. Engineering control of operator exposure must be used where reasonably practicable in addition to the following personal protective equipment: WEAR SUITABLE PROTECTIVE CLOTHING (COVERALLS), SUITABLE PROTECTIVE GLOVES AND FACE PROTECTION (FACESHIELD) when handling the concentrate. However, engineering controls may replace personal protective equipment if a COSHH assessment shows that they provide an equal or higher standard of protection. DO NOT CONTAMINATE SURFACE WATERS OR DITCHES with chemical or used container. DO NOT RE-USE CONTAINER for any purpose. READ ALL PRECAUTIONS BEFORE USE HARMFUL BY INHALATION HARMFUL: DANGER OF SERIOUS DAMAGE TO HEALTH BY PROLONGED EXPOSURE THROUGH INHALATION RISK OF SERIOUS DAMAGE TO EYES TOXIC TO AQUATIC ORGANISMS, MAY CAUSE LONG-TERM ADVERSE EFFECTS IN THE AQUATIC ENVIRONMENT The (COSHH) Control of Substances Hazardous to Health Regulations may apply to the use of this product at work. This product is authorised for use under the Control of Pesticide Regulations 1986. Slippa is Authorised for use as an adjuvant with approved pesticides, ADJ. No. 0206 Slippa is a registered trademark and Abate is a trademark of Interagro (UK) Ltd Interagro UK Ltd Sworders Barn, Sworders Yard North Street, Bishops Stortford Herts CM23 2LD Tel: +44 (0) 1279 501995 Fax: +44 (0) 1279 501996 info@interagro.co.uk www.interagro.net ver. 10/01/05 • top